NEXT LEVEL RACIG Motion Platform V3 Fan Speed Error.

[Saufy]

Hi people...

I have a new Motion Platform since 1 week.
Now i get a message like this:

Speed of fan no. 3 is too low. Please check if fan works correctly.

If i update Firmware or restart it the fan works for a short moment and then it stops.
Maybe it shut down because it have only 27°c? I don't want to break anything.

Does anyone have experience with this issue?

 

[Saufy]

no one can help?

 

[yister]

I would just contact NLR support, they're great.

 

[FABRAArturo]

Hi people...

I have a new Motion Platform since 1 week.
Now i get a message like this:

Speed of fan no. 3 is too low. Please check if fan works correctly.

If i update Firmware or restart it the fan works for a short moment and then it stops.
Maybe it shut down because it have only 27°c? I don't want to break anything.

Does anyone have experience with this issue?

Hello, I have the same problem. Did you solve the problem? Thanks

 

[Saufy]

Hello, I have the same problem. Did you solve the problem? Thanks

Yes there was a cold solder joint... (kalte lötstelle) i fixed by myselfe.

 

[Breaddrone]

Yes there was a cold solder joint... (kalte lötstelle) i fixed by myselfe.

Hello, i have the same issue as you with the fan being "too slow" but mine is fan #1. How did you fix the cold solder?

 

[Saufy]

Hello, i have the same issue as you with the fan being "too slow" but mine is fan #1. How did you fix the cold solder?

Hi, i opened it and fixed it by myselve... there was n cable witch bad contact.