I've recently acquired a T100 wheel but the pedals are faulty. I've managed to get hold of a set of T300 pedals however, the modem connectors, that connect the pedals to the wheel, are different. On the T100 pedals, the bit that holds the connector in place is central whereas it is offset on the T300 pedals.
Does anyone know if a) if I just cut the offset plastic part off of the T300 connector and hold it in place somehow, the pedals will still work? or b) if I cut the connectors off completely and swap them round, will I be able to wire them back on and will the pedals work?
Any help would be much appreciated.
Thanks
Does anyone know if a) if I just cut the offset plastic part off of the T300 connector and hold it in place somehow, the pedals will still work? or b) if I cut the connectors off completely and swap them round, will I be able to wire them back on and will the pedals work?
Any help would be much appreciated.
Thanks