Hey
Hi
I have tried RGB REV LIGHTS w SIMHUB but can not get the LEDs to work.
I bought these components:
I have tried to connect it like this.
SO;
VCC -> 5v
GND -> GND
10 -> DIN
all the arrows on the conductors are in the same direction and point away from the arduino.
Here are my simhub setup:
when up upload to aruduino:
Then i try to test it in the test data editor:
But the leds dosent light up.
I haved tried to:
- changed COM number
- changed the data pin from number 6 to number 10
- changed cable to the computer
- changed settings for the rpms in simhub
Anyone have any suggestions on what I can do to make this work? O
Hi
I have tried RGB REV LIGHTS w SIMHUB but can not get the LEDs to work.
I bought these components:
I have tried to connect it like this.
SO;
VCC -> 5v
GND -> GND
10 -> DIN
all the arrows on the conductors are in the same direction and point away from the arduino.
Here are my simhub setup:
when up upload to aruduino:
Then i try to test it in the test data editor:
But the leds dosent light up.
I haved tried to:
- changed COM number
- changed the data pin from number 6 to number 10
- changed cable to the computer
- changed settings for the rpms in simhub
Anyone have any suggestions on what I can do to make this work? O