Cant get the LED's to work - RGB WS2812B + Simhub + Bootloader Black Pro Micro ATmega32U4.

[TheRaceIsOn]

Hey

Hi
I have tried RGB REV LIGHTS w SIMHUB but can not get the LEDs to work.

I bought these components:

I have tried to connect it like this.

SO;
VCC -> 5v
GND -> GND
10 -> DIN


all the arrows on the conductors are in the same direction and point away from the arduino.


Here are my simhub setup:

when up upload to aruduino:

Then i try to test it in the test data editor:

But the leds dosent light up.

I haved tried to:
- changed COM number
- changed the data pin from number 6 to number 10
- changed cable to the computer
- changed settings for the rpms in simhub


Anyone have any suggestions on what I can do to make this work? O

 

[TheRaceIsOn]

@TheRaceIsOn as RedBull48 said, i would also try to check the soldering aswell.

have actually already checked. Used a voltmeter yesterday and it seemed to work