Having fixed it yet,that doesn't come with the cutting bits!
"I'll get you Butler!"
What is the piece that cuts into the screw look like?
Also the screws are tiny and countersunk,be bloody hard to remove them by trying to cut into them without damaging the pedal faces.
Don't want to buy all this stuff if it doesn't work.
And remember, unscrewing is counter clockwise.
Yes,uninstalled al my race sims and got rid of all my sim gear including track ir and hotas,least my pc desk is nice and clean now.
Just playing with a Logitech gamepad now,over sim racing,waited for months for the dremel bits and they never came so I rushed to Bunnings and bought the bits but now all useless lol.
Lol send me the pedals, I'd like them for spares...but seriously your frustration tolerance does not seem very high, that's a lot of value down the binYes,uninstalled al my race sims and got rid of all my sim gear including track ir and hotas,least my pc desk is nice and clean now.
Just playing with a Logitech gamepad now,over sim racing,waited for months for the dremel bits and they never came so I rushed to Bunnings and bought the bits but now all useless lol.
Thanks panicpete,that did the trick.Yes, you have to take off the securing washer remove the plastic part. Try bending up the little flap at the flat side of the poti axle. Check this video to see how it works. Do not try to pry the plastic piece off as it will dig the flap deeper into the poti axle. For reassembly I suggest bending the flap back down before putting the washer on again.
I wouldn't recommend taking the potis themselves apart as in the video however. Should be sufficient to spray some electrical cleaner into the potis from the outside to wash out the dirt.