Hi folks, I've been using a G27 for a long time but recently was given some newer gear, including a T3PA Pro, everything else works fine such as the wheel and shifter but the T3PA Pro pedal set lacks all of the internal guts.
It isn't really a huge issue because I'm planning on building a board to handle the three analog inputs via Xinput on an arduino, but where im hitting a stumbling block is I dont have the original gears that fit on over the pots that interface with the teeth of the pedal base.
Could someone with these pedals do me a huge solid, take off the black metal plate, slide one of these gears off and take either a clear picture of the gear from the side (so i can replicate the part on 3d printer), or slap it on a scanner, and also take a measurement of the overall height of the part so I can get the scale right?
Would be happy to publicly post the part on shapeways for people to get replacements easilly should theirs ever break in future, too.
Thanks!
It isn't really a huge issue because I'm planning on building a board to handle the three analog inputs via Xinput on an arduino, but where im hitting a stumbling block is I dont have the original gears that fit on over the pots that interface with the teeth of the pedal base.
Could someone with these pedals do me a huge solid, take off the black metal plate, slide one of these gears off and take either a clear picture of the gear from the side (so i can replicate the part on 3d printer), or slap it on a scanner, and also take a measurement of the overall height of the part so I can get the scale right?
Would be happy to publicly post the part on shapeways for people to get replacements easilly should theirs ever break in future, too.
Thanks!
Last edited:
